User Instructions
- Insert Switch-Blade into handle making sure hexagon end locates correctly
- Push completely in until audible “click” is heard
- To release the Switch-Blade, turn the locking ring in the direction of the unlock symbol and pull the Switch-Blade from the handle

- Using the Torque Adjusting tool, turn the graduated dial until the desired torque setting is in line with the arrow
- It should be set to the manufacturers recommended torque setting for the component or installation being installed

Tech-Tips
- Our Torque Screwdriver has to be calibrated either every 12 months or 5000 ‘clicks’ (whichever comes first). To maximise usage before calibration, ensure you only click once when you have tightened your screw to the required torque.
- Keep and use your Torque Handle at an ambient temperature of 18ºC to 28ºC
- Ensure your torque handle does not deviate from perpendicular by more than 5%
- Always select the correct blade for the screw
- Ensure a positive location of the blade in both handle and screw
- When using torque settings between 1 – 2.5Nm it is good practice to turn the screwdriver slowly when approaching the set torque limit
- When using torque settings between 2.6 – 6Nm it is a good practice to approach the set torque limit in a brisk manner
- Store your Torque Handle at the lowest torque setting after use
Please note:
The Armeg Switch-Blade VDE range should only be used on live installations by those persons trained in such instances. To maintain the VDE rating of the tools, only Armeg VDE interchangeable screwdriver blades should be used within the Armeg Switch-Blade handles. A positive connection between blade and handle should be ensured.
Before use, the tools insulation should be checked for any damage. The VDE integrity cannot be guaranteed if the insulation is damaged in any way. If in doubt, replace the component in question.
Due to the technical nature of the tool and to ensure long-term compliance with torque setting legislation, please refer and adhere to this policy on calibration.
- All Armeg’s Switch-Blade Torque handles are designed and manufactured in accordance to, and comply with, ISO 6789:2017
- As such, they are checked and certified to operate within a +/- 6% tolerance of the set / desired torque level.
- After extended use, it is prudent to have your Switch-Blade Torque Handle calibrated.
- In accordance with ISO 6789:2017, Armeg recommends that after either 5000 uses or 12 months (which ever comes sooner) your Switch-Blade handle is calibrated.
- The first calibration should be 12 months from the date of purchase (or 5000 clicks, whichever comes sooner), not the date as found on the Calibration Certificate. Please retain the purchase receipt, alongside the Calibration Certificate for future reference.
- There are many specialist companies that offer this service, but please ensure that they work to, and comply with, the standards established in ISO 6789:2017.
Safety Guaranteed
- 1000V Rated
- VDE/Gs Approved
- IEC 60900



Click on the link below to view the technical data sheet
