Enquiry Form

    FAQs

    Am I using the wrong screwdriver?

    Sometimes users will use a Plus/Minus 1 Screwdriver instead of a Plus/Minus 2. This will be indicated by there being movement between the screwdriver blade and the screw recess. However, this movement can cause the Screwdriver to break as the blade is not driving on all the faces it has been designed for and the torque is applied to only 2 faces. We always advise using the correct screwdriver for the screw being driven to minimise the chance of any breakages.

    Can any tool with a ¼” shank be used in an impact driver?

    No, not all ¼” shank products can withstand the higher torque produced by an impact driver. We only give our Twister Impact Rated seal of approval to tools which can offer the performance and durability required. All our Twister products have the following in-built qualities which make them suitable for use in impact drivers:

    • Strong materials
    • Shock-resistant heat treatment process
    • Designed to resist torsional impact
    • International ¼” shank standard ISO 1173:200
    • Performance Tested
    Can I buy spares for my electrical box sinker?

    Yes, all kit components are available separately. You can even purchase replacement guide rods for the round and square cutters.

    Can you make bespoke drill bits?

    Yes, with our own product development team onsite at our Sheffield HQ, we can make bespoke products to fit your specific and individual requirements (subject to MOQ’s). Check out our ‘Bespoke’ page for further information.

    Do Armeg tools come with a warranty?

    Yes, your Armeg purchase is guaranteed against manufacturing defect or faults for a period of 12 months from the date of purchase. Should your product develop a fault or problem, then please call our customer services team on 01246 411081 or follow the ‘Product Returns’ guidance in the link at the bottom of the web page. Please note that any product subsequently found to be faulty will be covered under our Guarantee. Alternatively, if you have any issues or questions with your product’s performance, then please call our technical support team for further help.

    Do solid board cutter caps need to be glued or screwed in?

    No. The rebate and the floor covering will hold the cap in place which means you then have very easy repeat access.

    Do your VDE torque screwdrivers come with a calibration certificate?

    Yes, all our VDE Adjustable Torque Screwdrivers conform to EN ISO 6789:2003 and each comes with an individual certificate of calibration.

    I think my product may be faulty, what should I do?

    If you think your product has a fault or problem, please refer to our ‘Product Returns’ guidance which is available in the link at the bottom of the page.

    Where should I get my VDE torque screwdriver recalibrated?

    Our VDE Torque Screwdriver has to be calibrated either every 12 months or 5000 clicks (whichever comes first). The first calibration should be 12 months from the date of purchase (or 5000 clicks) not the date as found on the Calibration Certificate. We do not offer a recalibration service at Armeg, however, there are many specialist calibration companies that do. Please ensure that they work to and comply with the standards established in ISO 6789:2003. 

    Armeg. Always performs.

    Ask an Expert